– 19 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
•
Under some reception conditions, fine tuning may be necessary to improve the picture quality. In such cases, adjust the
manual fine tuning (MFT).
•
If the signal frequency is unstable due to environmental conditions, use auto fine tuning.
Skip Function
If you set “SKIP ON” for unnecessary Position numbers, these
will be skipped when selecting channels using
3
.
Example : Skipping Channel 13
Select Position 13 using the same method for select-
ing Position 12 (previous page).
Press
7
repeatedly to display the D5 screen. Press
8
and select “SKIP”.
Press
5
to switch the “SKIP” setting from “OFF” to “ON”.
This completes the setting for skipping Position 13.
Note:
• When “SKIP” is ON, the Position number is prefixed by
“
*
”.
Example:
*
13. To confirm this, select Position 13 using
the
6
and
2
buttons.
•
If you want to restore a skipped position number,
select it using the
6
and
2
buttons then switch the
“SKIP” setting to “OFF” as in step 2 above.
Manual fine tuning (MFT)
Press
7
repeatedly to display the D6 screen.
Press
8
and select “MFT”. Press
5
to start fine tun-
ing. Pressing “-” fine tunes to a lower frequency while
pressing “+” fine tunes to a higher frequency.
1
Auto fine tuning (AFT)
Press
7
repeatedly to display the D6 screen.
Press
8
and select “AFT”. Press
5
to switch it to “ON”.
This completes the setting.
Note:
• When you operate MFT, AFT is switched OFF
automatically. If you switch on AFT after fine tuning with
MFT, MFT may be cancelled.
• AFT may be set independently for each Position.
1
2
2
1
2
