11
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Programming the Remote Control
Controlling other brands of VCR’s and cable TV converters
1
Refer to the “
VCR code table
” (or “
Cable TV converter code
table
”) on pages 12 and 13 to find the code number that corresponds to
the brand name of your VCR (or converter).
If more than one number is listed, try each one separately until you find
the one that works.
2
Set the
TV/CABLE/VCR
switch to “VCR” (or “CABLE”).
3
Hold down
RECALL
while pressing the
Number
buttons for the three
digit code number for your brand of VCR (or converter).
4
Point the Remote Control at the VCR (or at the converter) and press
POWER
to test the code number.
–
If the right number was entered
, the VCR (or the converter) should
turn off.
–
If the VCR (or the converter) does not respond to the Remote
Control,
repeat steps 1 to 4 with another code number.
For future reference, write down the code numbers you used:
VCR CODE
CABLE CODE
Notes:
●
You have to reprogram the Remote Control when you change its batteries.
●
Some newer VCR’s are capable of working on either of two remote codes. These VCR’s
have a switch labeled “VCR1/VCR2”.
If your VCR has this kind of switch, and does not respond to all the code numbers for
your VCR brand name, set the switch to another position (“VCR1” or “VCR2”) and
reprogram the Remote Control.
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL
MUTE
CH
CH
VOL
VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
PAUSE
FF
SOURCE
STILL
PIP
SLOW
PIP CH
LOCATE
SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEO
FAV CH
A
EXIT
●
This Remote Control is preprogrammed to operate TOSHIBA VCR’s.
●
To use VCR’s other than TOSHIBA models (or cable converter), perform the following procedures before
operating.
RECALL
Number
Preparation
POWER
