85
Setting up your TV
Using HDMITM CEC
No Signal Power Down
The TV will automatically turn itself off after 15 minutes when no
signal is detected. You can change the setting to Off for the
following purposes:
v
Low signal strength of analog channel (no signal detection)
v
Only Audio L/R is connected to external input to listen to music
through the TV speakers.
To change the no signal power down setting:
1
From the
Options
menu, highlight
Power Management
, and
then press the
ENTER
button.
2
Highlight
No Signal Power Down
, and then press the
ENTER
button.
3
Press the
/▼(arrow) buttons to highlight the item you want to
change, and press the ◄/►(arrow) buttons to select
On
or
Off
.
v
Default setting for this feature is On.
v
A warning message will appear 1 minute before the TV turns off.
Using HDMI
TM
CEC
This is a new feature that uses CEC technology and allows you to
control Toshiba HDMI
TM
CEC compatible devices from the TV
remote via HDMI
TM
connection (see
)
When
Enable HDMI CEC Control
in the
HDMI CEC
Control
Setup
menu is set to
On
(see
“Setting up HDMITM CEC” on page
), the HDMI
TM
CEC functions described below will be enabled.
HDMI
TM
CEC playback device (DVD player, etc.) control
With your TV’s remote control, or using the HDMI
TM
CEC Player
Control menu, you can control the connected HDMI
TM
CEC
playback device you are watching.
Available remote control key functions
Button:
Description:
PLAY
Begin playback
STOP
Stop playback
PAUSE
Pause the picture during play or record mode
SKIP Forward
Skip Forward
SKIP Reverse
Skip backward
FF
Fast forward
Using HDMI
TM
CEC
