55
65L350U Toshiba 65" 1080p 120Hz LED TV
www.tv.toshiba.com
Changing channel settings
This section covers:
• Automatically scanning for channels
• Manually adding channels to the channel list
• Hiding channels
• Setting up the Favorites list
• Tuning to a favorite channel or input
• Deleting a favorite channel or input
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press
CH
S
or
CH
T
, your TV goes to the next or previous channel
in the channel list. The channel scan may take several
minutes.
1
Make sure that you have set up the
ANT / CABLE IN
jack before programming
channels. See
Setting up the ANT / CABLE IN jack
on page
2
Press
MENU
, press
S
or
T
to highlight
Installation
, then press
ENTER
.
3
Highlight
Channel Tuning
, then press
ENTER
.
4
Highlight
Auto Tuning
, then press
ENTER
. Your
TV scans for available channels. The scan may take
several minutes.
5
When the scan is complete, press
EXIT
to close the
menu. Your TV tunes to the first scanned channel.
Note
When you scan for channels, your TV
erases any channels already stored in the
channel list.
If a channel is not stored in the channel
list, you can:
• Use the number button on the remote
control to enter the channel number.
• Manually add the channel to the
channel list. See
on page
Notes
• If you created a 4-digit PIN, use the
number buttons to enter your PIN and
start scanning. For more information,
see
on page
.
• You can press
EXIT
to stop the auto
channel search, but you will need to
run the auto channel search again to
create a channel list.
