English
- 27 -
English
Configuring PC Picture Settings
PC Picture Settings (*)
(*)
While in VGA/PC mode, some sections in Picture
menu will be unavailable. Instead, VGA mode settings
will be added to the Picture Settings while in VGA/
PC mode.
PC Picture controls
Contrast
,
Brightness
and
Colour
adjustments in
this menu are identical to adjustments defined in TV
picture menu.
Select
Reset
and press
OK
button to reset the
adjustments.
Note:
For switching to
VGA/PC
source, press “
SOURCE -
”
button on your remote control and select VGA/
PC input.
Note that VGA/PC mode menu settings are available
only while the TV is in PC source.
PC Position
Select this to display PC position menu sections.
Autoposition
If you shift the picture horizontally or vertically to an
unwanted position, use this section to put the picture
into correct place automatically.
Highlight
Autoposition
and then press the
OK
button.
H Position
H (Horizontal) Position shifts the image horizontally to
right hand side or left hand side of the screen.
Press
Down
button until
H Position
is highlighted.
Press
Left
or
Right
button to adjust the value.
V Position
V (Vertical) Position shifts the image vertically towards
the top or bottom of the screen.
Press
Down
button until
V Position
is highlighted.
Press
Left
or
Right
button to adjust the value.
Dot Clock
Dot Clock adjustment corrects the interference
that appear as vertical banding in dot intensive
presentations like spreadsheets or paragraphs or
text in smaller fonts.
Press
Down
button until
Dot Clock
is highlighted.
Press
Left
or
Right
button to adjust the value.
Phase
Depending on the resolution and scan frequency that
you input to the TV Set, you may see a hazy or noisy
picture on the screen. In such a case you can use this
item to get a clear picture by trial and error method.
Press
Down
button until
Phase
is highlighted.
Press
Left
or
Right
button to adjust the value.
