8
Controls and input connections
If the RED LED is unlit check that the mains plug is connected
to the power supply. If the picture does not appear press
i
on the remote control, it may take a few moments.
To put the television into Standby press
i
on the remote
control, the GREEN active standby LED will appear
(
see ‘Software Upgrade’ section
) next to the RED for a few
moments then disappear. To view the television press
i
again. The picture may take a few seconds to appear.
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the top of the television may be used for some functions.
To alter the volume press
—
j
+
.
To alter the programme position press
e
e
F
f
f
.
Press
MENU
and
S
,
R
,
Q
or
P
to control the sound
and picture options.
Press
MENU
twice to finish.
When connecting mono sound equipment to
EXT5
,
connect the audio output of the equipment to the
L/Mono socket on the television.
To select the Input, press
B
until the display shows
EXT5
as described on
page 28.
The television will
automatically sense the type of signal.
Please always refer to the owner’s manual of the
equipment to be connected for full details.
Please note:
Inserting the headphone plug will mute the
sound from all speakers.
Switching on
Using the controls and connections
Standby
GREEN – Active standby
RED – Power on
INPUT 5
(EXT5)
The television
screen can swivel
on its foot stand
15 degrees to the
left and right.
☛
Press the ATV/DTV button to select between digital
and analogue mode.
Press the
MENU
button on the remote control to see the
menus.
In
digital
mode the menu appears as a list of topics. Press
the
P
and
Q
button to highlight a topic, press
OK
to see
available options.
In
analogue
mode the menu bar at the top of the screens
will show five different topics shown in symbols. As each
symbol is selected by pressing the
S
or
R
button on the
remote control, its respective options will appear below.
To use the options press the
P
and
Q
button on the
remote control to move up and down through them and
OK
,
S
or
R
to select the required choice. Follow the on
screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the remote control