122
Expansion Options
Using PC Cards
To send information to both the built-in display panel and the
external monitor, change the Power On Display option.
To do this using the hot key:
1
Press
Fn
and
F5
simultaneously.
2
While holding down
Fn
, press
F5
repeatedly until you get the
desired setting.
This hot key cycles through the settings in the following
order: built-in display only, external monitor only, and
simultaneous display.
3
Release the
Fn
key.
HINT: Simultaneous mode works only with external monitors
that support 640 x 480 resolution and higher.
Using PC Cards
You may insert two Type II cards or one Type III card into the
stacked PC Card slots. These slots contain two spacekeeper inserts
to keep dust and dirt out of the computer. If you are not using a PC
Card, leave the inserts in place. If you are using a PC Card,
remove the insert and keep it in a safe place for future use.
The optional Multimedia Port Replicator provides an additional
single Type II PC Card slot.
PC Cards are credit-card sized expansion cards that greatly
increase the capabilities of your computer.
Some PC Cards combine several functions. Multifunction cards
allow you to get the most out of your PC Card slots.
Summary of Contents for 3490CT - Portege - PIII 700 MHz
