24
Setting up
y
our T
V
Selecting the signal source
Use the
INPUT
button on the remote control (or the
TV/VIDEO
button
on the TV) to monitor or change the signal source connected to your TV.
To monitor the signal source:
Press
INPUT
(or
TV/VIDEO
) once. The current signal source
displays in green.
To change the signal source:
Repeatedly press
INPUT
(or
TV/VIDEO
). The selected signal
source displays in green.
TV
VIDEO 1
VIDEO 2
VIDEO 3
ColorStream
VIDEO 1
VIDEO 2
ANT 1
VIDEO 3
ColorStream
ANT 2
Pressing INPUT
Pressing TV/VIDEO
on the remote control
on the TV
Adding channels to the TV’s memory
When you press
CHANNEL
▲
/
▼
on the TV or remote control,
the TV stops only on the channels stored in the TV’s memory.
Note:
To tune the TV to a channel not programmed in the TV’s
memory, use the
CHANNEL NUMBERS
on the remote control.
Follow the steps below and on the next page to program channels into
the TV’s memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in the TV’s memory. After the channels are stored automati-
cally, you can manually add or erase individual channels (see page 25).
If you use both ANT-1 and ANT-2 terminals, you will need to program
channels for each input source.
To program channels automatically:
1. Press
MENU
.
2. Press
x
or
•
to highlight the SET UP menu.
3. Press
y
or
z
to highlight TV/CABLE.
4. Press
x
or
•
to highlight TV (if you use an antenna) or CABLE (if
you use cable).
5. Press
z
to highlight CH PROGRAM.
MOVE SELECT [ ]
[ ]
LANGUAGE:
ANT1/2:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
MORE
[ENGLISH] FRANCAIS ESPANOL
[ANT1] ANT2
[TV]
CABLE
[ADD] ERASE
SET UP
MOVE SELECT [ ]
[ ]
LANGUAGE:
ANT1/2:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
MORE
[ENGLISH] FRANCAIS ESPANOL
[ANT1] ANT2
[TV] CABLE
[ADD] ERASE
SET UP
6. Press
x
or
•
to start automatic channel programming (“CH PRO-
GRAM” displays on-screen). The TV automatically cycles through
every TV or cable channel (depending on which you selected), and
stores all active channels in the TV’s memory.
7. When automatic channel programming is complete, the message
“CH Programming Completed” appears.
8. Press
CHANNEL
▲
/
▼
to view the programmed channels.
MENU
y z x •
EXIT
INPUT
CHANNEL
NUMBERS
MENU
y z x •
TV/VIDEO
CHANNEL
y z
MENU
TV / VIDEO
VOLUME
CHANNEL
POWER
CHANNEL
y
/
z
