1
5-3 Color Temperature Adjustment
(1) Set the signal generator to RGB, 1024*768, 60HZ(ASTRO-859: PG1 856), Level:178 (70%).
Full white pattern.
(2) Press up or down key of remote control to select “Cool”, Press ENTER key to enter the item.
R, G, B drive values are set for COOL, Medium, and WARM independently.
Color Cool Medium Warm
x 0.262
0.2840
0.313
y 0.262
0.297
0.329
Adjust
Tolerance
±0.003 ±0.003 ±0.003
(3) Select Cool
(1) Cool spec.:
: x = 0.262
y = 0.262
(2) If the x and y value are larger than specification,
Decrease Red drive from default value.
Increase Blue drive from default value.
(3) If the x or y or both x and y value is/are smaller than specification.
Increase Red drive from default value
Decrease Blue drive from default value
(4) According to a x and y value, please following adjustment of (4-1) or (4-2).
(4-1) If x value is higher than spec
Decrase Red drive from default value.
(4-2) If y value is higher than spec,
Increase Blue drive from default value
(4) Select [Medium]
Medium spec.:
: x = 0.2840
y = 0.297
Adjust R drive (RED) or B drive (BLUE) to set x and y above.
(5) Select [WARM]
WARM spec.:
: x = 0.313
y = 0.329
Adjust R drive (RED) or B drive (BLUE) to set x and y above.
(6) Exit Factory Mode:
After finish adjusting color temperature,press [
EXIT
] to exit factory mode.
