Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V
’s
F
eatur
es
Appendix
Index
12
Programming the remote control for use with a
non-Toshiba VCR or cable TV converter
The TV remote control is preprogrammed to operate Toshiba VCRs
and cable TV converters (see page 11). To use the remote control to
operate a non-Toshiba VCR or cable converter:
1. Refer to the VCR and cable TV converter code tables on pages 13
and 14 to find the corresponding code for your VCR or cable TV
converter.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are programming the remote control to operate your:
•
VCR,
set the TV/CABLE/VCR switch on the remote control
to VCR.
•
Cable converter,
set the TV/CABLE/VCR switch on the
remote control to CABLE.
3. While holding down RECALL, press the Number buttons (0–9)
to enter the three-digit code for your brand of VCR or converter.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
If the VCR or converter responds, you have entered the right
code.
If the VCR or converter does not respond, you may have entered
the wrong code. Repeat steps 1–4 using another code.
5. Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the codes you used:
VCR code:
_____________________
Cable TV converter code: _____________________
Note:
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.” If
your VCR has this kind of switch and does
not respond to any of the codes for your
VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
TV
CABLE
VCR
EXIT
1
2
3
4
5
6
7
8
9
100
0
ENT
POWER
MUTE
CH RTN
RECALL
CH
VOL
MENU/
ENTER
VOL
CH
POWER
Channel
yz
Channel
Number
Enter
RECALL
