Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.
31
Chapter 3: Using the remote control
+
PA
G
E
–
ACTION
ENTER
MENU
THEATER
NET
FAV
–
100
+10
POWER
Numbers
MODE
y
VOL
y
/
z
Programming the remote control to operate your other devices
(continued)
RECALL
To reset the volume controls to the original device mode:
1. While holding down RECALL, press 8 – 0 – 0 – 0.
2. Press VOL
z
.
The mode light will blink four times (unlocked).
Operational feature reset (8900)
This feature clears all setup features not related to “Device code
set up” and resets the Volume Lock to “TV.”
To reset the features:
While holding down the RECALL button, press 8 –9 –0 – 0.
The Mode indicator will blink two times, and then pause
and blink two more times.
Volume
TV
CBL/SAT
VCR
DVD
AUD1 AUD2
locked to:
TV (default)
TV
TV
TV
TV
AUD1 AUD2
CBL/SAT
CBL/SAT CBL/SAT CBL/SAT CBL/SAT AUD1 AUD2
VCR
VCR
VCR
VCR
VCR
AUD1 AUD2
DVD
DVD
DVD
DVD
DVD
AUD1 AUD2
AUD1
AUD1
AUD1
AUD1
AUD1
AUD1 AUD1
AUD2
AUD2
AUD2
AUD2
AUD2
AUD2 AUD2
Using the volume lock feature (8000)
For the TV, CABLE/SAT, VCR, and DVD modes, the volume
controls (VOL
y
/
z
and MUTE) can be locked to the selected
device mode. This feature does not apply to the AUDIO 1 and
AUDIO 2 modes.
To lock the volume controls to always control the
CABLE/SAT device volume (for example):
1. Repeatedly press MODE to select CABLE/SAT mode.
2. While holding down the RECALL button, press 8 – 0 – 0 – 0.
3. Press VOL
y
.
The CABLE/SAT mode light will blink two times (locked).
The following table details the volume lock implementation.
