16
MAINTENANCE
Please clean the rust by a soft cloth or a soft cloth with a cream cleaner.
* Do not use metallic brush because the body may scratch and easily rust.
Stainless rust
The stainless tub usually prevents the rust. However, there
is possible to have it. Please follow the recommendation
below to prevent rust.
If the stainless steel wash basket rusts for external reasons
•
Do not put the metallic objects into the machine, e.g. Hair
clip.
•
After draining the water, the rusted water will be drained.
This will caused the accumulated rust inside the washing
machine. Clean it again with clean water.
Install your washing machine in a level, stable place.
•
It is dangerous to place the washing machine in an
unstable location since it
may move during vibration.
•
It will increase the sound
produced by the machine
when it vibrates during use.
When you move washing machine, hold the handles on
the sides.
There are moving parts, electrical parts and steel
plates which may cause electrical shock or injury.
•
Never touch on the cabinet
bottom by hands.
Never lift at the cabinet
bottom by hands.
When the machine is covered.
Do not use the cover made of chloric vinyl. Sometimes it
damages resinous parts and painted surface. When you
use the cover made of chloric vinyl, put the cloth between
the machine and the cover.
Avoid place where the machine is exposed to direct
sunlight.
•
Plastic parts may become
deformed or discolored.
Avoid places where the machine may become frozen
during cold weather.
Allow a space of at least 5 cm from the sides and 10
cm. from the back side of the machine to the nearest
vertical object.
•
When placed too near
to walls or other objects,
the vibration of the machine
during operation may cause
them to shake.
Caution:
Be careful for backside space (must more than
10 cm.), otherwise the pump drain hose may be
bend effect to water drain problem.
Choosing an installation location
INSTALLATION
If the filling water b
ecomes not good
The water inlet may be blocked by foreign
objects. Remove the water supply hose
and clean the filter with a b
rush.
•
If you remove the water supply care-
lessly, water may splash. Therefore, use
the following procedure.
Removing the water supply hose
1
Turn the water faucet off.
2
Turn the power switch ON and
press the START/HOLD button.
3
After indicating the water level,
loosen the hose nut of the machine
top and remove it.
Water
supply port
Filter
In case of water may freeze
Drain all water from the
basket, drainage hose
and water supply hose
after using the machine.
If the water is frozen
•
Fill warm water into the basket until the pulsator is completely covered.
Leave it for 30 minutes. Then check to see whether the pulsator can be
turned by hand.