17
If the stainless basket rust for external reasons
Please clean the rust by a sponge or a soft cloth with a cream cleaner.
* Do not use metallic brush because the body may scratch and easily rust.
■
Stainless rust
The stainless basket usually prevents the rust.
However, there is possible to have it. Please
follow the recommendation below to prevent
rust.
•
Do not put the metallic objects into the machine, e.g. Hair clip.
•
After draining the water, the rusted water will be drained. This
will caused the accumulated rust inside the washing machine.
Clean it again with clean water.
Washing machine body and panel
Before performing any maintenance on your washing machine, be sure to remove the electrical plug from its power source.
The main body and control panel may be cleaned by wiping with a soft cloth soaked in water.
(Hard-to-remove dirt may be cleaned by wiping with a soft cloth soaked in a mind detergent.)
Caution:
Never clean the body or control panel with benzine, thinner, cleanser, or other chemical cleaners. Use of such
chemicals can discolor or damage parts.
Cleaning the tub
“TUBCLEAN” course
The dirt from clothes or wastewater on the wash/
spin basket will cause the smell or the problem of
water draining. Such dirt from the washing pro-
cess will then make the laundry dirty. If you are in
such case,
please use “TUBCLEAN” course
twice a month.
Or in case the clothes have been
starched, please use the “TUBCLEAN” program to
remove the dirt of the starch from the basket.
“TUBCLEAN” Process
1
Turn the POWER
.
2
Press the
button and select “TUBCLEAN”.
3
Press the
button.
•
No indicator. All indicator will light off.
4
When the pulsator (spinning board) starts to spin, add
the chlorine-type whitening detergent about 300 ml. to
the basket.
•
Add it at the fi rst used water.
•
Do not put any clothes in the basket during the
“TUBCLEAN” program.
5
Close the lid.
•
If the lid is opened during the operation, the operation will
stop before the draining and rinsing process.
Finish “TUBCLEAN” process.
•
Beeping when the operation is fi nished.
•
Do not use “TUBCLEAN” program continuously.
1 The pulsator stirs while the water level
increases gradually.
2 The water spins while draining out.
Water intake/Stir ( 1)
about 11 min
Soak about
20
min
Wash about
3
min
Drain/Spin
( 2)
about 3 min
Water intake/Stir ( 1)
about 11 min
Rinse about
3
min
Drain/Spin
( 2)
about 3 min
The water inlet valve may be clogged by lees or grimes.
a
You should remove inlet hose
Removing the water inlet hose
1
Turn off the water faucet.
2
Press the
button.
3
After water level indicator will light up,
press the
4
Loosen the hose nut and then remove inlet hose.
If the filling water becomes not good
Hose nut
Inlet hose
Valve filter
Water inlet valve
and clean valve filter by brush.
button to switch on the washing
machine then press the
button.
a
If you remove the water supply
carelessly, water may splash.
Therefore, use the following
procedure.
1
2