Trouble Shooting
•
display shows other alarm code again, contact the service center
• E1-E4 alarm clear on some models need to be stimulated by "Start" button
After
the
checking
,
try to use the appliance again ,If problems persist or the
.
.
Description
Description
Reason
Solution
10
20
No
washing
Inspection Items
If the power is off .
If the wate
r volume reache the required water level.
not work if the water amount does not reach the required water level)
If it is set to "Preset" washing mode. (It will only start to work until the
reservation time is reached)
(The washer will
No water
flows in
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the "Start / Hold" button is pressed after the power switch is pressed.
Abnormal
draining If the end of the water drain hose is placed very high.
If the end of water drain hose is
immersed in and blocked by a pool of water .
Abnormal
spin
If the
lid is closed.
If
If the washer is not placed in stable condition or it is placed
state. (The ground is not flat).
top
most of the clothing are at one side of the drum or if too many
clothes are loaded in the machine.
an inclined
E1
E7-1
E7-2
E7-3
E7-4
E7-5
E2
Check the water tap is
opened or not.
if
Check if the end of the drain hose is placed
too high,If it is immersed in and blocked
Alarm for abnormal
water
.
filling
Alarm for water
unfinished
water draining
Alarm for lid
not closed
before wash and spin.
that is
E3
Close
the lid.
E4
MAINTENANCE
Others
FXX
If the appliance does not start or it stops
during the operation,
initially
try
to
find
a
solution
to the problem based on the table below.
contact
the
service center
.
Otherwise,
Unbalanced wash load
during spinning
Evenly distribute the clothes in
the drum by hand
.
Call for service if no solutions work.
E7-1 E7-2 E7-3 E7-4 E7-5 appears after
pressing the power button,
If E7-1 E7-2 E7-3 E7-4 E7-5 appears
during the operation , press the power
button to stop the machine.
Please
call
for
service
.
Abnormal
behavior
with
dangerous
fault
.
(
break
wires brake sensors
)
,
,
Note!
