2. PRINTER SETUP
ENGLISH VERSION EO1-33055
2.9 Setting an Operating Environment
E2-20
2.9.1 Parameter
Setting
(Cont.)
When ON is selected, pressing the
[PAUSE]
key will result that the LCD
Message Display shows the stop position fine adjustment value setting
screen.
[FEED]
key: Pressing
the
[FEED]
key one time causes a –0.1mm change,
up to –5.0 mm.
[RESTART]
key: Pressing the
[RESTART]
key one time causes a +0.1mm
change, up to +5.0 mm.
After selecting an auto forward wait, press the
[PAUSE]
key.
(10) Control Code Selection
This parameter is to choose a Control Code.
When “<2>PARAMETER SET” appears, press the
[PAUSE]
key until
the following display appears.
Use the
[FEED]
or
[RESTART]
key to select a desired option.
When “CODE MANUAL” is selected and the
[PAUSE]
key is pressed,
the LCD display will show the setting screen of CONTROL CODE1 to
CONTROL CODE3 as follows.
POSITION +5.0mm
POSITION +0.0mm
[RESTART]
[FEED]
POSITION -5.0mm
POSITION +0.0mm
CODE AUTO
CODE AUTO
CODE ESC,LF,NUL
[RESTART]
[FEED]
CODE{|}
CODE MANUAL
Automatic selection
Manual selection
Manual selection
Control codes should
be specified.
CONTROL CODE1 1B
[RESTART]
[FEED]
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 01
CONTROL CODE1 00
CONTROL CODE1 FD
CONTROL CODE1 02
