1. PRODUCT OVERVIEW
ENGLISH VERSION
EO1-33055
1.1 Introduction
E1- 1
1. PRODUCT
OVERVIEW
1.1 Introduction
1.2 Features
1.3 Unpacking
Thank you for choosing the TOSHIBA B-852 series label/tag printer.
This Owner’s Manual contains from general set-up through how to
confirm the printer operation using a test print, and should be read
carefully to help gain maximum performance and life from your printer.
For most queries please refer to this manual and keep it safe for future
reference. Please contact your TOSHIBA TEC representative for further
information concerning this manual.
The B-852 printer has the following features:
•
A 8.3 inch wide print head is installed in such a compact body that the
size of the printer body (except the Supply Holder Unit) is about 1/3
of the B-SX6T or B-SX8T printer.
•
The print head block which can be fully opened realizes great
operability.
•
Various kinds of media can be used since the black mark sensors are
located above and under the media passage, respectively, and the
media sensors can be moved from the center to the left edge of the
media.
•
When the optional interface board is installed, Web functions such as
remote maintenance and other advanced network functions are
available.
•
Superior hardware, including the specially developed 11.8 dots/mm
(300 dots/inch) thermal print head which will allow very clear print at
a printing speed of 50.8 mm/sec. (2 inches/sec.) or 101.6 mm/sec. (4
inches/sec.).
•
Besides the optional cutter module, there is also an optional
Expansion I/O Interface Board, Serial Interface Board, Wireless LAN
Board, and Real Time Clock.
Unpack the printer as per the Unpacking Instructions supplied with the
printer.
NOTES:
•
Check for damage or
scratches on the printer.
However, please note that
TOSHIBA TEC shall have no
liability for any damage of
any kind sustained during
transportation of the product.
•
Keep the cartons and pads for
future transportation of the
printer.
