CHAPTER 3 INTERFACE
B-EP
Series
3-71
e
RECEIPT mode (Storing graphics)
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
STX Printer ID Printer status Battery level
02H xxHxxH 00H xxH
STX Printer ID Printer status Battery level
02H xxHxxH 10H xxH
Repeat when there is a
next print job.
[ESC]SG; . . . [LF][NUL]
e
Graphic command
Data
storage
Confirmation
of the printer
status prior
to data
storage
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Make sure that the printer
is in idle state.
c
Request for a Bluetooth
connection
c
Response to the request for a Bluetooth
connection
d
Status sent in response to the status
request command.
Host
Printer
f
Request for a disconnection
of the Bluetooth connection
f
Response to the request for the disconnection of
the Bluetooth connection
e
Status indicating a normal termination of data
storage (when an automatic status transmission is
enabled.)
Normal termination
d
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior to
a data transmission.)
Finish the data storage operation and
return to Main Menu or another screen.
