CHAPTER 4 TRANSMISSION SEQUENCE
B-EP
Series
4-26
4.3 LABEL
MODE
4.3.1 INITIAL
SETTING
[ESC] XP: Declares the termination of form storage.
Start
[ESC] M: Changes the mode to the LABEL mode as
required.
End
Status Request Command
< Completion of mode selection >
< Completion of form storage >
Mode Select Command
[ESC] FM: Checks the printer state by the status
request.
Check to see if the mode has been changed by the
status request.
Check to see if the form storage has been completed
by the status request.
Check to see if storage of the graphic data has been
completed by the status request.
Check to see if storage of the writable character data
has been completed by the status request.
[ESC] XO: Declares the start of form storage.
[ESC] D: Sets the label size.
[ESC] AY: Adjusts the print density as required.
[ESC] AX: Adjusts the print position as required.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the barcode/2-D code format.
[ESC] N: Sets the graphic field format.
[ESC] XD: Stores the writable character data.
[ESC] SG: Stores the graphic data.
Form Store Start Command
Label Size Set Command
Print Density Fine Adjust Command
Print Position Fine Adjust Command
Outline Font Field Command
Barcode/2-D Code Format Command
Graphic Field Command
Form Store Terminate Command
Graphic Data Store Command
No
No
Yes
Yes
< Completion of all form storage >
No
Yes
< Completion of storing graphic data >
Yes
Writable Character Data Store Command
No
Yes
[ESC] PC: Sets the bit map font format.
Bit Map Font Field Command
[ESC] LC: Sets the line format.
Line Format Command
<
Completion of storing writable
characters
>
No
