CHAPTER 5 TPCL MODE (INTERFACE COMMANDS)
B-EP
Series
5-2
[Reference] Flowchart for determining whether to perform a back feed and the stop position (Batch issue)
(*2): Whether to perform a back feed or not is determined depending on the combination of Conditions
2 and 3.
Conditions for performing a back feed
Back feed
<Condition 2>
Label pitch
<Condition 3>
Back feed restriction in the system mode
Less than 20.0mm
OFF (Performed.)
Performed.
ON (Not performed.)
Not performed.
20mm or above, but less than 24.0mm,
and
Effective print length: Less than 15.0mm
OFF (Performed.)
Performed.
ON (Not performed.)
Not performed.
20mm or above, but less than 24.0mm,
and
Effective print length: 15.0mm or above
OFF (Performed.)
Performed.
ON (Not performed.)
Performed.
24.0mm or above
OFF (Performed.)
Performed.
ON (Not performed.)
Performed.
Label pitch set for FEED key and Feed
command: 11.5mm or less
OFF (Performed.)
Performed.
ON (Not performed.)
Performed.
Label pitch set for FEED key and Feed
command: Over 11.5mm
OFF (Performed.)
Not performed.
ON (Not performed.)
Not performed.
<Condition 3>
Back feed
None
Present
Back feed: Yes
Stop position: Cut
Back feed: No
Stop position: Cut
Back feed: No
Stop position: Head
Confirmation of
printer conditions
<Condition 1>
Sensor setting
by command
<Conditions 2&3>
Conditions for
performing a back
feed (*2)
<Condition 5>
Stop position
setting
<Condition 4>
Print data within
9.3mm from a start of
printing
Cut position
Print head position
Performs a back
feed.
Performs no
back feed.
OFF: Performs a
back feed.
ON: Performs no
back feed.
Sensor is
specified.
Sensor is not
specified.
A
A
