CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-39
Chinese CG is required to print the character type: r.
Korean CG is required to print the character type: s.
When any character type of 52 to 55 is specified, it is invalid. However, an error does not
occur, instead a blank is printed.
If any character type out of the range is specified, a command error occurs.
(5)
Fine adjustment of character-to-character space
If no character-to-character space is specified or the number of space dots between
characters is 0, drawing will take place according to the horizontal spacing/proportional
spacing determined for each character. If character-to-character space is specified,
drawing will take place according to the value obtained by adding the character
spacing/proportional spacing to the specified value.
Point of
origin
(Horizontal spacing/proportional
spacing) × Horizontal magnification
Point of origin of
next char.
No. of fine adjust space dots
between characters
