CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-41
(7)
Selection of character attribution
If the print ratio of one line (the print head width) is higher than defined, printing may
become poor, or the printer may be reset. When “Reverse character” is selected for
how to clear and the black dot pattern is increased, be careful about the print ratio.
(8)
Bold character designation
(9)
Check digit to be attached
When Modulus 10 or Modulus 43 is selected, the check digit of a data row is calculated
and attached to the data row for drawing. In case of Modulus 10, when the data includes
any data other than numerals, drawing is not performed. In case of Modulus 43, when
the data includes any data other than CODE39, drawing is not performed, either.
When DBP Modulus 10 is selected, the check digit of a data row is calculated and only the
check digit is drawn. When the data includes any data other than numerals, drawing is
not performed.
When the font type is U, V, r, s or w, the check digit cannot be designated.
(Even if it is designated, it is ignored.)
* DBP Modulus 10 is Modulus 10 for Deutsche Bundespost Postdienst only.
Black characters
B
A
No. of dots in the
horizontal direction
Reverse characters
No. of dots in the
vertical direction
B
A
B
A
No. of dots in the
horizontal direction
No. of dots in the
vertical direction
Boxed characters
No. of dots in the
horizontal direction
B
A
Stroked out characters
0°
90°
Horizontally
bold
Vertically
bold
Vertically/
horizontally
bold
Horizontally
bold
Vertically
bold
Vertically/
horizontally
bold
