CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-91
(3)
More than one Barcode Format Command can be connected when transmitted.
[ESC] XB01; 0100, 0150, 3, 1, 02, 02, 06, 06, 02, 0, 0150 [LF]
B02; 0350, 0150, 3, 1, 02, 02, 06, 06, 02, 0, 0150 [LF] [NUL]
(4)
When the drawing data is changed per label issue during printing, the field of the drawing
data for the previous label is automatically cleared using the barcode number, then the
next drawing data is printed. Therefore, the barcode number which differs according to
the drawing fields should be designated.
(5)
Since the automatic field clear is not performed between the Clear Command ([ESC] C)
and Issue Command ([ESC] XS), the fixed data may be drawn using the same barcode
number. In this case, the Format Command and Data Command should be sent
alternately. (After the Issue Command is sent, the fields with the same barcode number
are automatically cleared until the Clear Command is sent.)
(6)
The link field designation is cleared by omitting the link field designation using the same
barcode No. and reformatting data. The link field designation can be also cleared by the
Image Buffer Clear Command.
(7)
A print data string and link field No. cannot be programmed at the same time.
(8)
In the case of the compatible mode for the B-SP series, the reserved area is not checked.
Refer
to
•
Bit Map Font Format Command ([ESC] PC)
•
Outline Font Format Command ([ESC] PV)
•
Barcode/Two-dimensional Code Data Command ([ESC] RB)
