CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-122
(5)
1-module
width
The width of 2 to 6 modules is automatically calculated by designating a 1-module width.
[Example of setting]
203-dpi print head (1 dot = 1/8 mm)
Type of barcode
1 module
2 modules 3 modules 4 modules 5 modules 6 modules
Bar Space Bar Space Bar Space Bar Space Bar Space Bar Space
MicroPDF417
2 4 6 8 10
12
(6)
No. of columns/rows
For the MicroPDF417, not only the number of columns (data strings) but also the number
of rows (data lines) can be designated. When these are to be designated, see the table.
Note that the max. number of digits for the set parameter (gg) varies according to the
character type. If data over the max. number of digits for the set parameter (gg) is set,
the two-dimensional code is not printed. The number of columns (data strings) is varied
in a range from 1 to 4.
Though the max. number of lines is 44, it depends on the number of columns.
Values to be set in ff: “1-module width”
To be automatically calculated based
on the value set in ff: “1-module width”
