CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-128
5.6.10 TWO-DIMENSIONAL CODE FORMAT COMMAND (QR Code)
[ESC] XB
Format
c
[ESC] XBaa; bbbb, cccc, d, e, ff, g, h (, Mi) (, Kj) (, Jkkllmm) (= nnn --- nnn) [LF] [NUL]
d
[ESC] XBaa; bbbb, cccc, d, e, ff, g, h (, Mi) (, Kj) (, Jkkllmm) (; oo
1,
oo
2,
oo
3,
------ , oo
20
)
[LF] [NUL]
Term
aa:
Two-dimensional code number
00 to 31
bbbb:
X-coordinate of the print origin of the two-dimensional code
Fixed at 4 digits (in 0.1 mm units)
cccc:
Y-coordinate of the print origin of the two-dimensional code
4 or 5 digits (in 0.1 mm units)
d:
Type of two-dimensional code
T: QR
code
e:
Designation of error correction level
L: High density level
M: Standard level
Q: Reliability level
H: High reliability level
ff:
1-cell
width
00 to 52 (in units of dots)
g:
Selection of mode
M: Manual mode
A: Automatic
mode
h:
Rotational angle of two-dimensional code
0: 0°
1: 90°
2: 180°
3: 270°
Mi:
Selection of model
(Omissible. If omitted, Model 1 is automatically selected.)
i = 1: Model 1
2: Model 2
Kj:
Mask
number
(Omissible. If omitted, the number is automatically set.)
j = 0 to 7: Mask number 0 to 7
8:
No mask
Jkkllmm:
Connection
setting
(Omissible. If omitted, connection is not made.)
kk = 01 to 16: Value indicating which divided code is connected.
ll = 01 to 16:
Number of divided codes
mm = 00 to FF: A value for all print data (before divided) which have
been XORed in units of bytes.
