CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP
Series
5-136
5.6.11 TWO-DIMENSIONAL CODE FORMAT COMMAND (MaxiCode)
[ESC] XB
Format
c
[ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) (= mmm ------ mmm) [LF] [NUL]
d
[ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) (; nn
1,
nn
2,
nn
3,
------ , nn
20
) [LF] [NUL]
Term
aa:
Two-dimensional code number
00 to 31
bbbb:
X-coordinate of the print origin of the two-dimensional code
Fixed at 4 digits (in 0.1 mm units)
cccc:
Y-coordinate of the print origin of the two-dimensional code
4 or 5 digits (in 0.1 mm units)
d:
Type of two-dimensional code
Z: MaxiCode
e:
Mode selection (Omissible)
•
When the MaxiCode specification is set to “TYPE1: Compatible with the
current version” in the SYSTEM mode.
Omitted:
Mode
2
0: Mode
2
1: Mode
4
2: Mode
2
3: Mode
3
4: Mode
4
5: Mode
2
6: Mode
6
7: Mode
2
8: Mode
2
9: Mode
2
•
When the MaxiCode specification is set to “TYPE2: Special specification” in
the SYSTEM mode.
Omitted: Mode 2 or Mode 3(*)
0:
Mode 2 or Mode 3(*)
1: Mode
4
2: Mode
2
3: Mode
3
4: Mode
4
5:
Mode 2 or Mode 3 (*)
6: Mode
6
7:
Mode 2 or Mode 3 (*)
8:
Mode 2 or Mode 3 (*)
9:
Mode 2 or Mode 3 (*)
*: Mode 2 or Mode 3 should be determined depending on the country
code of the data command. When the country code is 840, Mode 2
should be selected. For other codes than 840, Mode 3 should be
selected.
Jffgg:
Connection setting (Omissible. If omitted, connection is not made.)
ff:
Code number
01 to 08
gg: No. of divided codes
01 to 08
