CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
B-EP
Series
6-13
Notes
(1) The set fine adjustment value for print position is backed up in memory (retained
even if the power is turned off).
(2) The factory default value is 0.0 mm.
(3) The fine adjustment value for print position and strip position changed by the
Position Fine Adjust Command in the TPCL mode, is also effective in the LABEL
mode. However, the fine adjustment value for back feed changed in the LABEL
mode is not effective in the TPCL mode.
(4) When the back feed amount fine adjustment is enabled, printing starts at 3 mm
from the leading edge of the label.
(5) The back feed amount fine adjustment is enabled only while the command is being
stored in a form. It is disabled when the command is sent without being stored in
a form.
(6) When print position fine adjustment is selected in the SYSTEM mode (through key
operations on the printer), the fine adjustment value is a sum of the value in the
fine adjustment command and the system mode fine adjustment value. Note that
the maximum fine adjustment value is ±50.0 mm.
(7) The fine adjustment value for strip position up to V1.0C is valid only when the fine
adjustment value for print position is not selected (fine adjustment value = 0).
(8) When the label pitch length is 20.0 mm or more but less than 24.0 mm and the
effective print length is 15.0 mm or more or the label pitch length is 24.0 mm or
more, a back feed is performed before printing.
± 0 mm
+5 mm
-5 mm
Print start position
(Standard: 5 mm from the leading edge of the label)
Paper feed direction
Print start position
Print start position
