CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
B-EP
Series
6-44
6.5.10 two-dimensional CODE FORMAT COMMAND
(QR CODE)
[ESC]
XB
Function
Sets the format to indicate the position on the label, at which the two-dimensional code
is to be printed and how it is to be printed.
Format
[ESC] XBaa; bbbb, cccc, d, e, ff, g, h (, Mi) (, Kj) (, Jkkllmm), nn, o, p [LF] [NUL]
Term
aa:
Two-dimensional
code
No.
00 to 99
(The same No. must not be used in one form for the bit map font field, the
outline font field, and the two-dimensional code field.)
bbbb: Print origin of X-coordinate of the two-dimensional code
Fixed at 4 digits (in units of 0.1 mm)
cccc: Print origin of Y-coordinate of the two-dimensional code
Fixed at 4 digits (in units of 0.1 mm)
d:
Type of two-dimensional code
T:
QR
code
e:
Designation of error correction level
L: High density level
M:
Standard
level
Q:
Reliability
level
H:
High
reliability
level
ff:
1-cell
width
01 to 09 (in units of dots)
g:
Selection of mode
M:
Manual
mode
A:
Automatic
mode
h:
Rotational angle of two-dimensional code
0:
0°
1:
90°
2:
180°
3:
270°
Mi:
Selection of model
(Omissible. If this parameter is omitted, Model 1 is automatically selected.)
i = 1: Model 1
2:
Model
2
Kj:
Mask
number
(Omissible. If this parameter is omitted, the number is automatically set.)
i = 0 to 7: Mask number 0 to 7
8:
No
mask
Jkkllmm: Connection setting (Omissible. No connection if this parameter is omitted.)
kk = 01 to 16:
Value indicating which divided code is connected.
ll = 01 to 16:
Number of divided codes
mm = 00 to FF: A value for all data to be printed, to which XOR is applied in
units of bytes (Not divided)
