CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
B-EP
Series
6-50
Origin of
coordinates
(0, 0)
Paper feed direction
Print origin of
coordinates
Effective print width
Effective
print length
Backing paper
Label
0
X
Y
Explanation
(1)
Two-dimensional
code
No.
The data in the Data Print Command (X) is selected and linked in the order of this
barcode/two-dimensional code No. (The formats of barcode/two-dimensional
code Nos. 00 and 01 are linked to the first and second data, respectively. In the
same order, the format is linked to the data.) Therefore, the Nos. of the bit map
font character string, the outline font character string, and the barcode/two-
dimensional code, should be consecutive, starting from 00 (in ascending order).
The same No. must not be used in one form for the bit map font character string
field, the outline font character string field, and the barcode/two-dimensional code
field.
(2) Print origin of coordinates
(3) Type of check digit
The check digit is automatically attached according to the type designation as
shown below.
Barcode
type
C/D type
NW7, CODE39,
Interleaved 2 of 5
JAN8/EAN8,
JAN13/EAN13
EAN128,
UCC/EAN128,
CODE128
1
Without attaching check
digit
No designation
No designation
3 No
designation
Auto attachment of
Modulus 10
Auto
attachment of
PSEUDO103
