CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP
Series
8-38
8.10.23 SWITCHING TO STANDARD MODE COMMAND
[ESC] S
Function
Makes transition from page mode to standard mode.
Format [ESC]
S
Term ASCII:
ESC
S
Hex: 1Bh 53h
Explanation
(1) This command will be valid only if it is executed in page mode.
(2) The data expanded in page mode is erased.
(3) After this command is executed, the next print starting position is the beginning of a
line.
(4) The following commands have different values in page and standard modes. So,
the values are switched to the ones for standard mode.
1
Spacing
Set [ESC]
[SP],
[FS]
S
2
Line Feed Length Set [ESC] 2, [ESC] 3
(5) Standard mode is selected at power-on, when resetting, or when the Initialize
Command ([ESC] @) is executed.
(6) The print area defined by the Page Mode Print Area Set Command ([ESC] W) is
initialized.
Reference
Page Mode Print Command ([FF])
Page Mode Collective Print Command ([ESC] [FF])
Switching to Page Mode Command ([ESC] L)
