CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP
Series
8-52
8.10.36 CHINESE
CHARACTER
UNDERLINING SET COMMAND [FS] -
Function
Sets or cancels underlining for ANK characters.
Format [FS]-n
Term ASCII:
FS-
Hex: 1Ch 2Dh
[Parameter]
n: Setting underlining for Chinese character 0
≤
n
≤
2 (00h
≤
n
≤
02h)
or
48
≤
n
≤
50 (30h
≤
n
≤
32h)
0: Canceling underlining
1: Setting underlining (1-dot wide)
2: Setting underlining (2-dot wide)
Default value
n: 0
Explanation
(1) Chinese characters including space on both sides of them are underlined.
However, a portion skipped by the Horizontal Tab Command ([HT]) or a character
rotated 90 degrees clockwise is not underlined.
(2) If underlining Chinese characters is canceled with n = 0, the subsequent Chinese
characters will not be underlined. However, the width of the underline immediately
before canceling the underline is maintained. Also, a 1-dot wide underline is
selected by default.
(3) The width of an underline for Chinese characters is consistent regardless of a
character size.
(4) Underlining Chinese characters can also be set or canceled by the Chinese
Character Print Mode All Set Command ([FS] !), but the most recently processed
command is applied.
(5) The parameter setting applies to the Chinese language settings with Chinese
language implemented for the QM model (destined overseas), or to the Korean
language setting with Korean language implemented.
Reference
Chinese Character Print Mode All Set Command ([FS] !)
