< 5 >
Date
Modified
Pages
Description
Jun. 20, 2013
(Continued.)
11-11, 11-
13, 11-15,
11-17, 11-
18
Message, “BT Initializing”, has been added.
11-20
When the old Bluetooth module (V244) is used, an error message, “SYSTEM
ERROR 18”, is not displayed and a recovery is not performed.
11-21,
11-
22
Section 11.15.1 Recovery of bonding table has been newly added.
Jun. 4, 2014
5-1, 5-2
Explanation of back feed and stop position for firmware V1.0E or later has
been added.
5-3
A supplementary explanation about the back feed in the strip issue for
firmware V1.0E or later has been added.
9-2
9.2.3 LAN DRIVER ERROR has been added.
11-20
A description that a recovery processing is not performed when the Bluetooth
module firmware version is before V257 has been added.
11-22
Verification of the Bluetooth module version has been added to the flowchart.
Dec. 5, 2014
2-2
New model, B-EP-GH32, has been added.
2-5, 3-54
Specification of the B-EP-GH32 Bluetooth module has been added.
3-74
3.7.5 COMBINATION OF BLUETOOTH MODEL AND APPLICABLE
FIRMWARE VERSION has been added.
10-1
Bluetooth (B-EP-GH32) has been added as unusable interface for
communication. (10.3 Communications Conditions)
10-25 to 10-
32
Restrictions (specification) concerning the B-EP-GH32 have been added.
(Device nickname, Inquiry, Interval, Window, Bonding, Security)
Explanation of the conditions when a status 38H/39H (38/39) is sent to the
host has been added.
11-12, 15,
17, 19, 20
An LCD message, “SSP AUTH FAILED,” has been added.
11-22, 23
A note has been added to notify that the B-EP-GH32 does not support the
recovery function.
A note regarding the B-EP4DL-GH30-FE-QM-R has been added to the BD
address recovery.
