CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP
Series
8-89
Status in the compatible mode for the B-SP series
00H:
Normal
state
(idling)
01H:
Cover
open
state
02H: Command syntax error (including Ir packet error)
03H:
Paper
jam
04H:
Label
end
05H: Cover open error
06H: Broken head dots error
07H: Thermal head excessive temperature
(including ambient temperature error, abnormal battery temperature, battery
excessive temperature)
08H: Flash ROM write error
09H: Flash ROM erase error
0AH: Low battery (Print failure)
0BH:
Operating
(including wait for strip, pause state, bit map writable character/PC command
mode, wait for battery recovery, wait for head temperature reduction, wait for
motor temperature reduction)
0CH: Communication error * For RS-232C connection only
0DH: Normal end + Label end
(See
NOTE
.)
0EH: Flash ROM storage area full state
10H: Normal issue end
37H:
Charging
error
(38H: Bluetooth setting successfully completed) Response status for automatic status
transmission
39H: Bluetooth setup error (including initialization error)
NOTE:
0DH (Normal issue end + Label end) is a state when the printer runs out of
labels, after a label is issued.
Battery status The battery charge status is indicated in 5 levels.
(B-EP2DL)
01H: 7.2V or less
02H: 7.3V to 7.4V
03H: 7.5V to 7.7V
04H: 7.8V to 7.9V
05H: 8.0V to 8.4V
(B-EP4DL)
01H: 14.0V or less
02H: 14.1V to 14.6V
03H: 14.7V to 15.2V
04H: 15.3V to 15.9V
05H: 16.0V to 16.8V
CRC: 2-byte hex data (in order from Low to High)
