CHAPTER 11 OTHER FUNCTIONS
B-EP
Series
11-14
No.
LCD Message of the
Upper Line
(English)
Printer Status
Detail Status
Auto Status
Transmission
Status Request
Command
14
FLASH MEM FULL
Saving failed because of insufficient space in the
flash memory.
0EH 0EH
“54” “54”
15
EEPROM ERROR
A back-up EEPROM cannot be read/written
properly.
16
LOW BATTERY
The battery voltage has dropped to 7.2V or less for
B-EP2DL, or 14V or less for B-EP4DL.
0AH 0AH
“36” “36”
17
AMBIENT TEMP ERR
An ambient temperature has dropped to -20
°
C or
lower, or exceeded 60
°
C.
07H 07H
“18” “18”
18
BATT. TEMP ERROR
The battery may be heated and hurt operators.
Please be careful not to get burned.
07H 07H
“18” “18”
19
HIGH VOLT. ERROR
The battery may be heated and hurt operators.
07H 07H
“18” “18”
20
SYSTEM ERROR --
System error
(a) A command has been fetched from an odd
address.
(b) Word data has been accessed from a place
other than the boundary of the word data.
(c) Long word data has been accessed from a
place other than the boundary of the long word
data.
(d) The logical area ranging from 80000000H to
FFFFFFFFH has been accessed in user mode.
(e) An undefined command in a place other than
the delay slot has been decoded.
(f) An undefined command in the delay slot has
been decoded.
(g) A command which rewrites the data in the
delay slot has been decoded.
21
WAITING (BATT.)
The battery protection function is active.
0BH
“02”
22
WAITING (HEAD)
The print head protection function is active.
0BH
“02”
23
WAITING (MOTOR)
The motor protection function is active.
0BH
“02”
24
BT INIT ERROR
The initialization of Bluetooth failed.
39H
“39”
25
BT SETTING ERROR
There is an error in the Bluetooth setting.
39H
“39”
26
CHARGE ERROR $
An error occurred while the battery was recharged.
37H 37H
“37” “37”
27
Ir PACKET ERROR
A block number error occurred in the TEC protocol.
02H 02H
"06" "06"
28
Display of error
command
(See
NOTE 1
.)
A command error has been found in analyzing the
command.
02H 02H
“06” “06”
