CHAPTER 11 OTHER FUNCTIONS
B-EP
Series
11-16
11.12 LCD MESSAGES AND LED INDICATIONS
The model and the firmware version are displayed on the character-oriented LCD.
No.
LCD Messages of
Upper line
(English)
LED
Indication
Printer Status
Restoration
by the
[PAUSE]
key
Yes/No
Acceptance
of Status
Request and
Reset
Commands
Yes/No
STATUS
1
ON LINE
{
In the online mode
- Yes
ON LINE
{
In the online mode
(Communicating)
- Yes
LBL PRESENT ****
A label is waiting to be stripped.
- Yes
2
COVER OPEN
{
The front cover was opened in the online
mode.
- Yes
3
PAUSE ****
z
In a pause state
Yes Yes
4
COMMS ERROR
A parity error, overrun error or framing
error has occurred during communication
through the RS-232C interface.
Yes Yes
5
PAPER JAM ****
A paper jam has occurred during paper
feed.
Yes Yes
6
NO PAPER ****
The paper has run out.
Yes Yes
7
NO PAPER
A label has been completed normally, and
then the paper has run out.
Yes Yes
8
COVER OPEN
A feed or an issue was attempted with the
print head opened (except the [PAUSE]
key).
Yes Yes
9
HEAD ERROR
A broken element has been found on the
thermal head.
Yes Yes
10
EXCESS HEAD TEMP
The print head temperature has exceeded
71
°
C.
No Yes
11
SAVING #### &&&&
{
In writable character or PC command
save mode
- Yes
12
FORMAT ERROR
An erase error has occurred in formatting
the flash ROM on the CPU board.
No Yes
13
FLASH WRITE ERR.
An error has occurred in writing data into
the flash memory.
No Yes
14
FLASH MEM FULL
Saving failed because of insufficient
space in the flash memory.
No Yes
15
EEPROM ERROR
A back-up EEPROM cannot be
read/written properly.
No No
16
LOW BATTERY
The battery voltage has dropped to 7.2V
or less for B-EP2DL, or 14V or less for B-
EP4DL.
No Yes
17
AMBIENT TEMP ERR
An ambient temperature has dropped to -
20
°
C or lower, or exceeded 60
°
C.
Yes Yes
18
BATT. TEMP ERROR
The battery may be heated and hurt
operators.
Please be careful not to get burned.
No Yes
19
HIGH VOLT. ERROR
The battery may be heated and hurt
operators.
No Yes
