CHAPTER 3 INTERFACE
B-EP
Series
3-44
3.5.2
NOTES WHEN SENDING A COMMAND
• In the LABEL mode, when any of the commands below are sent, the host should send the next
command after receiving the process end status. If the host sends the next command before
receiving the process end status, the printer may discard it without receiving.
• Print Density Fine Adjust Command (If it is not stored in the form)
• Print Position Fine Adjust Command (If it is not stored in the form)
• Form Store Terminate Command
• Graphic Data Store Command
• Printer ID Set Command
• Flash Memory Storage Area Format Command
• Writable Character Data Store Command
•
Status
Request
Command
•
Mode
Select
Command
• Strip Sensor Adjust Command
•
Data
Command
* When automatic status transmission is not specified by the Data Print Command, the
issue end status is not sent. Therefore, check the printer status by transmitting the
Status Request Command. When the printer status is idling, the next command
should be sent.
• In the TPCL mode, when the automatic status response is selected, the host sends a response
when receiving an error, print end, or feed end status.
• In the RECEIPT mode, the host sends a status when receiving an error status, though there is
no automatic status response selection. To the print end and feed end statuses, the host does
not return any status.
• In the ESC/POS mode, the automatic status response cannot be selected. To the print end
and feed end statuses, the host does not return any status. (A response is made with the
Status Request Command only.)
