CHAPTER 3 INTERFACE
B-EP
Series
3-62
h
TPCL mode (Issue)
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
E.g.)
[ESC]XS;I,0001,0002C1011
[LF][NUL]
Status response is
enabled.
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 30H30HxxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
The printer is in operation.
e
Label size set command to
Issue command
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 34H30HxxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
e
Status indicating a normal termination of issue
Normal termination
A status request
command does not
need to be sent.
Issue
Waiting
time until
the end of
a print job
d
Status sent in response to the status
request command.
Confirmation
of the printer
status prior
to data
storage
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
c
Request for a Bluetooth
connection
c
Response to the request for a Bluetooth
connection
Host
Printer
f
Request for a disconnection
of the Bluetooth connection
f
Response to the request for the disconnection of
the Bluetooth connection
d
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
