CHAPTER 3 INTERFACE
B-EP
Series
3-66
f
RECEIPT mode (Issue)
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Min. 100msec.
STX Printer ID Printer status Battery level
02H xxHxxH 00H xxH
Provide 100 msec. or more wait
time after the termination of data
transmission via Bluetooth.
Print data including a line
feed command [LF]
e
Print data
Issue
Confirmation
of the printer
status prior
to data
storage
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
Make sure that the printer is
in idle state.
c
Request for a Bluetooth
connection
c
Response to the request for a Bluetooth
connection
d
Status sent in response to the status
request command.
Host
Printer
f
Request for a disconnection
of the Bluetooth connection
f
Response to the request for the disconnection
of the Bluetooth connection
d
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
