CHAPTER 3 INTERFACE
B-EP
Series
3-68
h
TPCL mode (Issue)
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Status response is
enabled.
Min. 100msec.
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 30H30HxxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
Provide 100 msec. or more wait
time after the termination of data
transmission via Bluetooth.
E.g.)
[ESC]XS;I,0001,0002C1011
[LF][NUL]
The printer is in operation.
e
Label size set command to
Issue command
Issue
d
Status sent in response to the status
request command.
Confirmation
of the printer
status prior
to data
storage
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
c
Request for a Bluetooth
connection
c
Response to the request for a Bluetooth
connection
Host
Printer
f
Request for a disconnection
of the Bluetooth connection
f
Response to the request for the disconnection
of the Bluetooth connection
d
Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
