[X-coordinate]:
Sets a fine adjustment value to offset the print position perpendicular to the paper feed direction in
units of 0.1 mm.
When the value is negative (-), the upper right reference coordinate shifts to the left from the zero
point.
Default
0.0 mm
Range
-99.5 to +99.5 mm
[Tone Adjustment] Group
[Thermal Transfer]:
Sets a fine adjustment value for print density in the thermal transfer print mode.
The fine adjustment value set by the Print Density Fine Adjust command [AY] is displayed in the left
box.
When the parameter is not retrieved, the value in the left box becomes zero (0).
Default
0
Range
-20 to +10
[Direct Thermal]:
Sets a fine adjustment value for print density in the direct thermal print mode.
The fine adjustment value set by the Print Density Fine Adjust command [AY] is displayed in the left
box.
When the parameter is not retrieved, the value in the left box becomes zero (0).
Default
0
Range
-20 to +10
[Command] Group
[Control Code]:
Selects a control code used for command analysis.
Default
AUTO
Options
AUTO, [ESC] [LF] [NUL], { | }, Manual
[Code 1]:
When "Manual" is selected for the [Control Code], sets a code for the first byte in a HEX format.
Enter two alphanumeric characters from "0" to "F".
Entries are not case-sensitive.
Two characters indicate one HEX character. (Example: "0" -> "30" or "A" -> "41")
Default
1B
Range
20 to FF
[Code 2]:
When "Manual" is selected for the [Control Code], sets a code for the second byte in a HEX format.
Enter two alphanumeric characters from "0" to "F".
Entries are not case-sensitive.
Two characters indicate one HEX character. (Example: "0" -> "30" or "A" -> "41")
Default
0A
Range
20 to FF
[Code 3]:
When "Manual" is selected for the [Control Code], sets a code for the third byte in a HEX format.
Enter two alphanumeric characters from "0" to "F".
Entries are not case-sensitive.
Two characters indicate one HEX character. (Example: "0" -> "30" or "A" -> "41")
Default
00
Range
20 to FF
Summary of Contents for B-EX4T1-T JP
