2. PRINTER SETUP
ENGLISH VERSION EO1-33094
2.6 Printer Setting
E2-30
2.6.9 System Mode
How to enter the System Mode
The System Mode consists of the following menus.
<1>DIAG.
Used to check and print the printer system information and
maintenance counter status.
<2>PARAMETER SET (
⇒
Section 2.6.2
)
Used to set the parameters for each printer function.
<3>ADJUST SET (
⇒
Section 2.9
)
Used to fine adjust the print position, cut position, print tone,
etc.
<4>TEST PRINT (
⇒
Section 2.8
)
Used to perform print tests.
<5>SENSOR ADJUST
Used to check the sensor statuses and set each sensor.
<6>RAM CLEAR
Used to perform a RAM clear. DO NOT USE this menu.
<7>INTERFACE (
⇒
Section 2.6.10
)
Used to set the interface parameters.
<8>BASIC (
⇒
Section 2.6.4
)
Used to set the function of basic program when it is loaded to
the printer.
<9>FOR FACTORY
Used for an in-process inspection. DO NOT use this menu.
<10>RFID
Used to set RFID related parameters.
(
see Installation Manual
in each RFID kit)
<11>RTC (
⇒
Section 2.6.11
)
Used to set the date and time of the real time clock, enable or
disable the low battery check, and choose a real time renewal
timing.
<12>Z-MODE (
⇒
Section 2.6.5
)
Same as BASIC
<13>USB MEMORY (
⇒
Section 2.6.12
)
Used to copy data to/from USB memory.
<14>RESET
Used to reset the printer.
Power OFF
System Mode
Power ON while holding down
[FEED]&[PAUSE]
Power ON while holding down
[MODE]
