-61-
7.3.8
Back Feed Restriction Setting (Backfeed Limit)
・
OFF
Back feed not restricted (Performs a back feed.)
・
ON
Back feed restricted (Performs no back feed.)
Default value: ON (Back feed restricted)
<Commentary>
During label issue with sensor type specified (transmissive/reflective sensor) under the following conditions, this
setting determines whether or not to perform a back feed.
However, when linerless setting is enabled, the following conditions are ignored and whether or not to perform a
back feed is determined according to this setting.
The label pitch is 20.0 mm or more and less than 24.0 mm and the effective print length is less than 15.0
mm.
The label pitch is less than 20.0 mm.
During label issue without sensor type specified, whether or not to perform a back feed is determined according
this setting.
When a feed is performed by using the [FEED] key or the Feed command, no back feed is performed.
However, when the label pitch is less than a distance between the head and the sensor (14.0 mm), a back feed
is performed regardless of this setting.
<Notes>
- If the setting is OFF, it stops at cut position in case 7.3.7
Post-print Stop Position Setting (Stop Position)
is HEAD.
*Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL
C Mode
ESC/POS
RECEIPT,RECEIP
T1
Z Mode
S Mode
o
o
o
o
o
