7. B-FV Setting Tool
EO18-33030
7.6 Working with B-FV Setting Tool (V1.0.34)
7-92
￭
D Mode, E Mode, I Mode, Z Mode and AUTO
D Mode
,
E Mode
,
I Mode
,
Z Mode
and
AUTO
provide settings grouped in the
Supply
,
Control
,
Action
,
Label
and
Position Adjustment
areas.
Note
:
“AUTO”
is not available at present, and to be supported in future.
mm/inch/dot conversion process in Position Adjustment is as follows;
1. Input to the form in Setting Tool
Unit
Value Setting condition
mm
The value is adjustable in increments of ± 0.1 mm and rounded to
the 1st decimal place.
inch
The value is adjustable in increments of ± 0.01 inch and rounded to
the 2nd decimal place.
dot
The value is adjustable in increments of ± 1 dot and rounded to an
integer place.
2. Units Conversion process
1) When sending the value of the printer
The Setting value is transmitted as
dot
information to the printer.
Case
Conversion process
Calculation (Setting value = A) Rounding method
Case 1
mm => dot
203dpi
A / 25.4 × 203
Rounded down to
an integer place
300dpi A
/
25.4
×
300
Case 2
inch => dot
203dpi
A × 203
300dpi A
×
300
Summary of Contents for B-FV4 Series
Page 41: ...2 ELECTRONICS SPECIFICATIONS EO18 33030 2 2 Main PC Board Layout 2 4 B FV4D GH B FV4D GL ...
Page 301: ...APPENDIX EO18 33030 APPENDIX Establishing a Bluetooth connection with B FV4D and B FV4T A 8 ...
Page 302: ...1 11 1 OSAKI SHINAGAWA KU TOKYO 141 8562 JAPAN E PRINTED IN JAPAN EO18 33030H ...
