1. OUTLINE
EO18-33030
1.6 Supply Specifications
1-23
1.6.2 Media Type (B-FV4D-GL)
The table below shows the size and shape of the media that can be used on this printer.
B-FV4D-GL
Unit: mm (inch)
Issue mode
Item
Cut mode
Label width
102.0 (4.0)
Cut length
25.4 to 152.4 (1.0 to 6.0)
Thickness
0.06 to 0.19 (0.0024 to 0.0075)
Max. outer roll diameter
Ø127 (5.0)
Roll direction
Outside wound
Inner core diameter
40.0 (1.57)
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC approved media.
2. A label jam is more likely to occur with the approach of label end because labels around the paper core
curl intensely.
1.6.3 Detection Area of the Feed Gap (Transmissive) Sensor
The Transmissive sensor is fixed and positioned at 6.35 mm (for GS/TS Type) or 6.27 mm (for GH Type)
right of the centre of the media path.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Min. 2 mm
(Min. 6 mm:
cut mode)
Min. 8 mm
Sensor position
Area to be detected
Label
Gap
Label
Sensor position
Media feed direction
Print side
6.35 mm (for GS/TS Type)
6.27 mm (for GH Type)
Feed Direction
Cut position
Label without liner
Summary of Contents for B-FV4 Series
Page 41: ...2 ELECTRONICS SPECIFICATIONS EO18 33030 2 2 Main PC Board Layout 2 4 B FV4D GH B FV4D GL ...
Page 301: ...APPENDIX EO18 33030 APPENDIX Establishing a Bluetooth connection with B FV4D and B FV4T A 8 ...
Page 302: ...1 11 1 OSAKI SHINAGAWA KU TOKYO 141 8562 JAPAN E PRINTED IN JAPAN EO18 33030H ...
