3. REPLACING THE IMPORTANT PARTS
EO18-33030
3.1 Replacing the Parts for B-FV4T-GS/TS
3-9
3.1.4 Replacing the Feed Gap Sensor / Black Mark Sensor
1. Refer to Section 3.1.2 to remove the printer module.
2. Reverse the printer module and then remove the black mark sensor.
3. Use a Phillips screwdriver to remove the 1 screw from the feed gap sensor (lower).
4. Take off the feed gap sensor (lower).
5. Use a Phillips screwdriver to remove the 1 screw from the feed gap sensor (upper) on the right side of
the printer module.
6. Take off the feed gap sensor (upper).
7. Replace the feed gap sensor or the black mark sensor with a new one and then reassemble it in the
reverse order of removal.
Black Mark Sensor
Screw
Feed Gap Sensor (lower)
Screw
Feed Gap Sensor (upper)
Summary of Contents for B-FV4 Series
Page 41: ...2 ELECTRONICS SPECIFICATIONS EO18 33030 2 2 Main PC Board Layout 2 4 B FV4D GH B FV4D GL ...
Page 301: ...APPENDIX EO18 33030 APPENDIX Establishing a Bluetooth connection with B FV4D and B FV4T A 8 ...
Page 302: ...1 11 1 OSAKI SHINAGAWA KU TOKYO 141 8562 JAPAN E PRINTED IN JAPAN EO18 33030H ...
