3. REPLACING THE IMPORTANT PARTS
EO18-33030
3.1 Replacing the Parts for B-FV4T-GS/TS
3-12
3.1.5 Replacing the Ribbon Sensor
1. Refer to Section 3.1.2 to remove the printer module.
2. Use a Phillips screwdriver to remove the 1 screw from the Ribbon Sensor on the left side of the printer
module.
3. Take off the ribbon sensor.
4. Replace the ribbon sensor with a new one and then reassemble it in the reverse order of removal.
5. After replacing, make sure the printer is performing correctly regarding the following points.
Printing is performed correctly and the ribbon is not slack or wrinkled.
When the ribbon is unloaded and thermal transfer printing is performed, an error occurs.
(The ribbon sensor detects the status correctly.)
Screw
Ribbon Sensor
Summary of Contents for B-FV4 Series
Page 41: ...2 ELECTRONICS SPECIFICATIONS EO18 33030 2 2 Main PC Board Layout 2 4 B FV4D GH B FV4D GL ...
Page 301: ...APPENDIX EO18 33030 APPENDIX Establishing a Bluetooth connection with B FV4D and B FV4T A 8 ...
Page 302: ...1 11 1 OSAKI SHINAGAWA KU TOKYO 141 8562 JAPAN E PRINTED IN JAPAN EO18 33030H ...
