Stratagy ES Model C1 Installation Guide
Step 4: Install Voice Board(s)
4
Stratagy ES Model C1 Installation Guide 12/01
Step 4: Install Voice Board(s)
➤
Insert the board’s edge connector into the first available ISA slot. Apply pressure only to the
top edge of the board, and gently rock the board back and forth to seat the edge connector into
the slot. Replace and tighten the retaining screw. Repeat this step for each board you are
installing.
Step 5: Check Hardware Connections
CAUTION!
During shipment, boards and cables can become loose and cause the system to
not work properly.
➤
Check to insure that all other boards and cables are properly seated.
Step 6: Complete Stratagy ES Hardware Setup
1. Replace the server’s
cover.
2. Connect the following
items (connections
shown at right):
•
Keyboard
•
Monitor
•
Mouse
•
SAM
•
Modem’s phone jack
to a PBX or CO line
using RJ11C
connectors and cables
The hardware portion of this installation is now complete.
1
1
0
V
Retaining
P
late
6009
Remove screw and lift cover plate to add/remove board.
Note: Only a ProLine/2V, Dialog/4 or D/41ESC board can be used in this model.
Voice Interface Card
Locked - Unlocked
Voltage Selection Switch
ISA Slot
NIC Card Connection
Monitor Port
COM Port
Back View
5974
Cover Release Button (blue)
Power Button
AC Power Cord Connection
LPT1 Parallel
Printer Port
Mouse
Keyboard
Stratagy
Activation
Module
To Printer
(optional)
Summary of Contents for C1
Page 15: ......