– 17 –
Compliant Manager
Installation Manual
8
ZONE SETTING
Register groups in a zone or cancel them.
(1) Change the mode to the zone setting mode.
• Press the
button,
button, and ZONE
button simultaneously for at least 4 seconds.
(The displayed zone number flashes and the Compliant Manager enters the zone setting mode. Indicates
CODE No. “E1”.)
(2) Select the zone to be set.
• Select the zone number to be set with the ZONE
or
button, and then press the
button to fix the
selection.
(When the selection has been fixed, the selected zone number flashes.)
• When selection of zone has been fixed, the
marks of the group numbers registered in the zone light up.
(3) Change registration of groups in a zone.
Register groups in a zone.
1. Select the group number to be set with the GROUP
or
button. Pressing the SET TEMP.
or
button skips the group number by +16 or by -16.
2. Press the
button.
The
marks of the registered group numbers light up. (
→
)
3. Pressing the
button restores the state before the
button is pressed.
4. To continue registration of groups, repeat this procedure from the beginning.
NOTE
No zone data has been stored at this time. If the ZONE
or
button is pressed before the registration
change is fixed, the set content for registration change is discarded.
(4) Fix the registration change.
Press the
button. The set content for registration change is stored in the memory.
* After the memory write operation has been completed, the Compliant Manager exits the zone setting mode.
16-EN