7
Set up
Preparation
Basic Operation
Advanced Operation
Reference Selection
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL
MUTE
CH
CH
VOL
VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
FF
SLOW PAUSE
STOP
PLAY
REC TV/VCR
TV/VIDEO
FAV CH
A
EXIT
Using the Remote with VCR or Cable TV Converter
●
To control a TOSHIBA VCR, first set the
TV/CABLE/VCR
switch to “VCR” position. The buttons shown
below will then control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 8.
●
To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your
converter. See page 8.
The shaded buttons can be used to control the cable TV converter.
Set the
TV/CABLE/VCR
switch to “CABLE” position whenever you control the cable TV converter.
CHANNEL
s
/
t
Press
s
to select next higher channel.
Press
t
to select next lower channel.
Aim at the VCR or cable TV converter
Channel Number
Press the numbers desired
for direct access.
TV/CABLE/VCR
“CABLE”: To control the
cable box
“VCR”:
To control the VCR
TV/VCR
Press to select the TV mode to
view one program while
recording another program.
REC
(record)
Press to start recording.
SLOW
Press to view a slow-motion
picture in playback mode.
PAUSE
Press to freeze the picture during
playback or recording.
Press again to release.
POWER
Press the button to turn the VCR
(or converter) on.
Press again to turn off.
ENTER
Some VCR's and Cable TV
converters require “ENT” to
change channel number.
STOP
Press to stop the tape.
PLAY
Press to begin tape playback.
FF
(fast forward)
Press to rapidly advance the tape.
In playback mode, press to view the
picture moving rapidly in forward
direction.
REW
(rewind)
Press to rewind the tape.
In playback mode, press to view
picture moving rapidly in
reverse.
