1. Remove the lower basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and pour in about 1.5kg of
dishwasher salt.
3. Fill the salt container to its maximum limit with water, It is normal for a small amount of
water to come out of the salt container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will stop being after the salt container has been filled with salt.
6. Immediately after filling the salt into the salt container, a washing program should be
started (We suggest to use a short program). Otherwise the filter system, pump or other
important parts of the machine may be damaged by salty water. This is out of warranty.
Please follow the steps below for adding dishwasher salt:
Warning
Only use salt specifically designed for dishwashers use!
Every other type of salt not specifically designed for dishwasher use, especially
table salt, will damage the water softener. In case of damages caused by the use of
unsuitable salt the manufacturer does not give any warranty nor is liable for any
damages caused.
Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water, which may have been spilled,
remaining on the bottom of the machine for any period of time, which may cause
corrosion.
Attention
The salt container must only be refilled when the salt warning light ( )
in the
control panel comes on. Depending on how well the salt dissolves, the salt warning
light may still be on even though the salt container is filled.
If there is no salt warning light in the control panel (for some Models), you can
estimate when to fill the salt into the softener by the cycles that the dishwasher has
run.
If salt has spilled, run a soak or quick program to remove it.
Adding salt to the softener
English
17
