The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise the
level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 55
German
dH
German
dH
Salt consumption
(gram/cycle)
Salt consumption
(gram/cycle)
0 - 9
10 - 20
21 - 30
31 - 40
41 - 60
61 - 98
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
0
9
12
20
30
60
French
fH
French
fH
Mmol/l
Mmol/l
Water softener level
Water softener level
British
Clarke
British
Clarke
WATER HARDNESS
H1
H2
H3
H4
H5
H6
dH=1.25 Clarke=1.78
fH=0.178mmol/l
°
°
°
1
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your
local Water Authority can advise you on the hardness of the water in your area.
1.
Close the door and s
witch on the appliance
.
2. Press the Start/Pause button for more than 5 seconds
,
when the salt indicator
flashes means entering
the water softener
settings.
set model within 60 seconds after the appliance was switched on
.
3. Press the Start/Pause button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6
.
4.
Without any operation in five seconds, the machine will exit from set mode, the
machine is into standby status.
Use the dishwasher
Water softener
Adjusting salt consumption
The manufactory setting: H3
Contact your local water board for information on the hardness of your water supply.
16